The SRE must only be replaced by personnel from motcom GmbH or its authorized representatives.
Installation and replacement of the SRE requires careful mechanical alignment as well as a precise synchronisation with the engine the SRE is installed to.
To ensure the high level of reliability crucial for operation, two steps must be carried out very carefully:
- The mechanical adapter must be centered with the engine crankshaft during initial installation, and after each re-installation.
- The SRE must be synchronized with the engine crankshaft. This procedure must be carried out during the initial installation, as well as after each dismantlement.
For the synchronization of the SRE it is necessary to position the engine at the firing TDC (refer to Chapter 6.2 Syncronization of the BeCOMS® Sensor SRE) at cylinder no.1 and to find the incremental encoder impulse offset (on 4-stroke engines the inlet and outlet valves are closed)
Replacing of the SRE only does not affect the centering of the mechanical adapter.
The system only has its full functionality if these steps are carried out carefully!