As soon as the Evaluator is powered up, it starts the initial self check procedure and shows the READY status if all pre-set conditions are fulfilled. This self check procedure is carried out in a certain cycle.
Regardless of the GREEN READY LED status of the Evaluator, if a working SRE is connected to it, the Evaluator samples the signals from the SRE at a certain sampling rate. After that, the Evaluator converts them into digital signals, analyzes, evaluates and displays them on its LC-display.
These data including detected events are continuously made available through the RS485 interface to the installed PC with Data_Logger software for remote monitoring and further processing. It is also possible to set up some Evaluator parameters from the PC using standard Windows HyperTerminal application.
Depending on the configuration, the Data_Logger software can manage up to 6 BeCOMS® systems on a single computer. The measured values and events will be monitored and displayed continuously on the computer, and stored in a distinct directory on the hard disk for each connected BeCOMS® system.