Installation / disassembly procedures are relevant to all designs of the mechanical parts and engines (the illustrations may represent the latest on-site installed assembly). Attention: The list shown here is an excerpt of the main installation manual. Mechanical installation Procedure on individual Engines Continue with Chapter “6 Commissioning”.
SiCOMS® – Installation Procedure of Mechanical Components Read More »
The position for the SiCOMS® sensors and SOG in the engine wall must be chosencarefully. Using existing drilled holes, for example used by an old oil mist detectionsystem, the installation is easy. Anyway, the splash oil concentration inside the engine is a very important factorand must be taken into consideration:Each engine type has got its own characteristics which influence the
Menu level 1 Menu level 2 Menu level 3 Description Test & Service View and change Evaluator test options and perform service procedures.Press [Enter] to switch to the sublevel: PIN for Setup must be entered in “Setup CPU” menu before using Test & Service menu. Otherwise, the following warning appears: P?? Table 1 Setup
Menu level 1 Menu level 2 Menu level 3 Description Setup CPU View and change Evaluator communication and display parameters.
Menu level 1 Menu level 2 Menu level 3 Description Setup Alminhibit View and change alarm inhibit parameters Press [Enter] to switch to the sublevel: PIN for Setup must be entered in “Setup CPU” menu before changing parameter. Otherwise, the following warning appears: P??
Menu level 1 Menu level 2 Menu level 3 Description COT measure setup Press [Enter] to switch to the sub level. PIN for Setup must be entered in “Setup CPU” menu before changing parameter. Otherwise, the following warning appears: P??
Menu level 1 Menu level 2 Menu level 3 Description Parameter setup View and change system parameters..Press [Enter] to switch to the sublevel:PIN for Setup must be entered in “Setup CPU”menu before changing parameter.Otherwise, the following warning appears: P??
Menu level 1 Menu level 2 Menu level 3 Description If one of the sublevels of this menu isentered, pressing [Esc] at this level restarts the Evaluator. This is necessary to apply the changes, if any, made to the settings.
Menu level 1 Menu level 2 Menu level 3 Description Peak accelaration force in g The bargraph displays peak accelaration force in g
Menu level 1 Menu level 2 Menu level 3 Description Oilmist concentration in mg/l The bargraph shows oil mist concentration in mg/l
