The following messages, displayed on the LCD of the Evaluator are possible System Ready! Standard message indicating that the system works and all measured values are in the permitted range. BeCOMS-Error 04First pulse sequence of incremental encoder – not connected BeCOMS-Error 08Second pulse sequence of incremental encoder – not connected BeCOMS-Error 16Synchronization signal of the incremental encoder – not connected […]
If the measured values displayed are outside of the physical possibilities of the engine, the problem must be examined in detail – error case!! Some examples of different causes: The recording and interpretation of the signals over a longer period is important. Changes of the signal could be evaluated based on the previous recorded data. Based on these results suitable
1. If the green READY LED of the Evaluator is off and the thermovoltage signal and/or RPM are displayed as zero or unstable on the LCD of the Evaluator (and in Data_Logger) at a running engine, then please conduct the following steps: 1) Check if cable connectors at the cable connecting SRE and the Evaluator are loose, if necessary, fix
The error messages displayed in Data_Logger are self-explaining, i.e. a communication problem with the Evaluator is depicted in Fig. 8.2 below. The operators should use the technical acceptable standards to trace the cause of the errors reported and skillfully fix the problem. If the problem cannot be solved, please contact motcom GmbH authorized representatives.
The BeCOMS® Data_Logger and Data_Indicator software is designed and tested to run under the following Microsoft operating systems: Please refer to Chapter 3.4 Optional Data Logger PC with Data_Logger Software for requirements to the personal computer needed for the software.
(optional) BeCOMS® Data_Logger is a PC program for displaying and storing the measured data. For detailed information on Logger software please refer to the BeCOMS® Data_ Logger user manual. Data_Indicator software is used for reading and analysing the BeCOMS® data files. For further information please refer to the BeCOMS® Data_Indicator user manual. i The daily data files created by BeCOMS®
BeCOMS® – Data_Logger measurement data storage and management Read More »
Exception In case of a communication error, the Evaluator has to be restarted to reactivate the System Ready status!
Attention Main-Alarm cannot be reset through the Data_Logger software, but only at the Evaluator by pressing the RESET-Button for 3 seconds.
There are 3 alarm relays integrated in the Evaluator: The BeCOMS® has a self test function which is carried out in a certain cycle. If any one of the conditions for System Ready status is not detected the Evaluator switches off the GREEN READY LED and the Ready relay opens. Error code and text error message are shown on the
